Write At Command Station V104 !!better!! (480p × HD)

void setup() { // Write a byte to EEPROM location 0 EEPROM.writeAt(0, 10);

void loop() { // Read the data from EEPROM location 0 byte data = EEPROM.read(0); Serial.print("Data at location 0: "); Serial.println(data);

// Write another byte to EEPROM location 10 EEPROM.writeAt(10, 20); write at command station v104

delay(1000); } In this example, we write the values 10 and 20 to EEPROM locations 0 and 10, respectively. Then, we read the data from these locations and print it to the serial console.

Serial.begin(9600); }

The WriteAt command is a part of the Arduino EEPROM library, which provides functions to read and write data to EEPROM. The WriteAt command specifically allows you to write a byte of data to a specific location in EEPROM.

#include <EEPROM.h>

Here's an example sketch that demonstrates how to use the WriteAt command:

The syntax of the WriteAt command is as follows: void setup() { // Write a byte to EEPROM location 0 EEPROM